Precautions for the production of smoked drying lines

Safety precautions for smoking and drying production:

1. This equipment must have professional responsible personnel to carry out operation and maintenance;

2. Before starting the operation, the key parts and equipment in the process should be carefully checked by the special person to meet the requirements of the equipment performance before they can be put into use. Equipment that is used for the first time after prolonged decommissioning and maintenance should be commissioned before use before it can be put into operation.

3. Check whether the reducer and the transmission part have been filled with lubricating oil one by one. Check and adjust the tightness of each belt.

4. Check steam pressure, electrical equipment, grounding protection of the motor, safety devices and insulation.

5, steam drying should always pay attention to the stability of the air pressure, the smooth flow of the trap;

6. Electrothermal drying adopts high-efficiency energy-saving heating pipe. When using, the whole machine should be grounded reliably. The grounding device must comply with relevant international standards and regulations;

7. During the smoking and drying operation, be sure to bring heat-resistant protective gloves and necessary protective equipment in places where smoked materials, ash and equipment are stored.

8. When the equipment is running, the drying room door of the equipment cannot be opened; if the following abnormal conditions occur, it is necessary to dissipate heat and smoke, and then eliminate the fault in time to reproduce;

1The area that is easy to block is blocked by materials;

2 Whether the conveyor belt runs over or over;

3 Whether the surface temperature of the motor and reducer and the temperature rise of the bearing exceed the specified range;

4 There is no looseness and dust leakage at the flange connection;

5 Whether the air duct and the flow tube are blocked or dusted;

6 Whether there is open welding and air leakage in hot air ducts and other welded parts;

7 Whether the current, voltage and steam pressure index of each equipment are normal;

8 The operation of each equipment, whether there is abnormal sound or abnormal smell;

9. After the work is completed, the smoke and heat must be discharged to clean and clean the internal mesh belt and the cigarette making box.