The sand mixer may be improperly designed due to improper design at the factory or not suitable for the specific conditions used by the unit. This requires repairing some devices, such as transmission components.
The method of improvement and repair of the transmission part is:
1. Assembly of large bevel gear The main shaft of the Sll6 sand mixer and the large bevel gear are originally designed as flat shaft ends. The weight of the whole cast large bevel gear with the material of HTl50 is more than 600kg. The large bevel gear is assembled under the grinding disc. Restrictions, poor neutrality, laborious and labor-intensive, and even endanger the safety of workers. In particular, the large bevel gear is the weak link of the sand mixer, and it has to be replaced if it is damaged.
A better method is to add a tapered end with a taper of 1:5 at the flat end of the new spindle. The specific structure is shown in Figure 3-20. When assembling the large gear, the gear hole is aligned with the conical end of the main shaft, and the three jacks are gradually jacked up to smoothly enter the mating end of the main shaft to achieve high assembly efficiency.
2. Improvement of transmission mode of Sll6 roller mixer The bearing seat of the original bevel gear is moved from the cement foundation to the underside of the chassis, and a bevel gear is added in a symmetrical position, which is connected by a through shaft. The small bevel gear on the right side is connected with the rotating shaft as a rotating pair to balance the force on the single side of the large bevel gear, and overcome the single-side wear of the main shaft bearing to avoid the left and right swing of the large bevel gear and the bevel gear movement.
Another method is to remove a pair of bevel gears and replace them with a pair of spur gears.
The bevel gear transmission section has been modified as shown in Figure 3-22. Two single-row tapered roller bearings are mounted in the bearing, the distance is l70mm, to improve the rigidity of the pinion shaft, and the distance from the first bearing to the pinion is shortened from the original 11Omm to 60mm, which greatly improves the pinion shaft. Carrying capacity, the pinion shaft will not break even if the load is suddenly increased during use.
Vitamins are a type of trace organic substances that humans and animals must obtain from food in order to maintain normal physiological functions. In terms of physiological functions, vitamins are neither a raw material for tissues nor a substance for supplying energy, but they are an indispensable substance for the body. It has many types and different chemical structures. Most of them are the components of the coenzyme (or prosthetic group) of certain enzymes. They are the indispensable compounds for maintaining the normal growth (growth, health, reproduction and production function) of the body. It plays a catalytic role in the body to promote the synthesis and degradation of major nutrients (proteins, fats, carbohydrates, etc.), thereby controlling metabolism. Vitamins are essentially low-molecular organic compounds. They cannot be synthesized in the body, or the amount synthesized is difficult to meet the needs of the body, so they must be supplied from the outside. The daily requirement of vitamins is very small (usually measured in milligrams or micrograms). They are neither a raw material for body tissues nor a substance for energy supply in the body. However, they do not regulate material metabolism, promote growth and development, and maintain physiological functions.
Vitamin K2 MK-7, Vitamin C, Vitamin E, Vitamin K2, Vitamin H, Vitamin D3
Xi'an Gawen Biotechnology Co., Ltd , https://www.ahualyn-bios.com