With the development of technology, belt vegetable dehydration dryer has satisfied the ability of large production, diversification, centralized control and continuous production, with the advantages of high efficiency, energy saving, etc., and in order to be able to work better, it needs to be installed. Be very careful and follow the steps as required.
Mesh belt type dehydrated vegetable dryer installation:
1. Draw the basic line: Make the cross line, the elevation line and the center mark on the basic target board to be easy to use, accurate and consider not to be covered after the base is installed.
2. Install the base and the tug: shovel the position of the horn, draw the base, the center line of the tug, according to the requirements of the drawings, find the installation position of the base and the tug, level and correct, first grout the foundation hole, and the concrete reaches a certain strength. When the anchor bolts are tightened, the cylinders are installed after the inspection is passed.
3. Install the cylinder and the rolling ring: firstly install the rolling ring on the cylinder. The concave joints required for fixing should be arranged in a reversed and reversed manner, and the thickness of the horn should be adjusted to keep the contact between the rolling ring and the concave joint. For the corresponding clearance, do not agree, and spot weld the concave joint bolt head and the cylinder body.
4. Install the big gear: Check the interface of the mating surface before installation, there must be no collision marks, clean the contact surface between the large gear and the cylinder, then carefully align the two halves of the gear and tighten the interface bolts, then install the large gear in the cylinder Physically. Rotate the barrel and check the radial runout and lateral swing of the large gear until the calibration is passed.
In general, the residence time of the mesh belt type dehydrated vegetable dryer in the middle section and the final drying section is three to four times that of the initial drying section, and the thickness of the paving is two to three times that of the initial drying section, effectively improving the drying. The output provides conditions for users to produce in large quantities in batches.
Manual Video Measuring Instrument
Manual image measuring instrument is a precision measurement instrument that uses manual driving for 3 axes, and the measurement software is manual point taking.
This instrument uses a zoom objective to magnify the measured object, and the image is input into a computer through a CCD industrial camera device. The enlarged image of the measured object is transmitted to the measurement software for non-contact and efficient geometric measurement of various complex workpieces.
Suitable for non-contact measurement of stamped parts, plastic parts, thin film shaped, easily deformed, easily damaged, and small-sized workpieces, such as workpiece measurement in industries such as rubber, plastic, small hardware, clocks, and light industry.Video Device
.
The manual image measuring instrument consists of three parts: an image acquisition device, a data acquisition device, and a two-dimensional measurement software. The zoom objective lens and high-resolution color camera form an image acquisition device, and the data acquisition device is composed of a grating ruler and a data processor. The image and data are measured using 2D measurement software to achieve point, line, arc, and distance measurements.
Manual Video Measuring Instrument,Fully Automatic Image Measurement ,Optical Measuring Instrument
Zhejiang dexun instrument technology co., ltd , https://www.dexunmeasuring.com