Linear vibrating screen requirements for grid

In addition to the requirements for the screen, the linear vibrating screen may also have a choice for the grid. The grid has a wooden grid and a steel grid. The two types of grids have their own advantages: wooden grid It is easier to replace the screen, but it is easy to damage; the steel grid is not easy to damage, but it is more troublesome to replace the screen. We will not elaborate here. In the following chapters, we will specifically say that here we mainly talk about the replacement of the screen and some matters to be noted.

1. After the linear screen grid is assembled to the screen box as required, it is important to extend the multi-cut 50-70mm screen into the corresponding discharge port to avoid mixing phenomenon.

2. When cutting, the width of the screen of the linear sieve and the grid are the same, and the length of the screen must be 50~70mm longer than that of the linear screen;

3. When the screen is installed, it must be tightened because the tension of the screen is an important factor affecting the efficiency of the screening of the linear screen;

4, when installing the net bouncing ball, we must pay attention to the difficulty and mesh of the screening of the material, can not be blindly installed;

5. When installing the linear sieve plate, be sure to pay attention to the flatness. If conditions permit, it is recommended to evenly lock the sponge seal with strong elasticity, because this is the key to prevent the occurrence of mixed grade, and it also affects the sieve. An important factor in the service life;

6. If the proportion of the material is large or the number of screens to be installed in the linear screen is high, the suitable net should be added under the screen. The purpose is to support and reduce the pressure on the screen. To extend its service life;

7. After the installation is completed, the material of the screen surface and the screening should be tested with a little material. If the material is evenly conveyed forward and the classification is accurate, there is no mixing phenomenon, it means that it can be put into use; otherwise, if there is deviation or If the pile is uneven, adjust the flatness and uniformity of the screen surface of the linear screen or adjust the angle of the eccentric hammer of the vibration motor. If there is a mixed phenomenon, check the seal of the linear screen and whether it is compacted.

Laser Distance Sensor

Leading Laser Measure Module Factory in China
The World's First single transmitting single receiving design laser module, which has a big help to reduce producing cost and power consumption of the laser distance sensor.
This Laser distance sensor has high Accuracy up to Â±1 mm, working as phase measure, which support RS232/RS422/RS485/Arduino to TTL communication.
This laser distance module is widely used in the Laser Distance Meter industry, also a very good choice for the Industrial applications. Most of measuring tools manufactures is purchasing from us in China.

Product Specifications:

Accuracy	Â±1 mm (0.04 inch)
Measuring Unit	meter/inch/feet
Measuring Range (without Reflection)	0.03-150m
Measuring Time	0.1~3 seconds
Laser Class	Class II
Laser Type	635nm, <1mW
Size	452512mm (Â±1 mm)
Weight	About 10g
Voltage	DC2.0~3.3V
Electrical Level	TTL/CMOS
Frequency	10Hz
Operating Temperature	0-40 â„ƒ (32-104 â„‰ )
Storage Temperature	-25~60 â„ƒ (-13~140 â„‰)

Range Sensor,Laser Distance Module,Distance Sensor,Laser Measure Sensor

Chengdu JRT Meter Technology Co., Ltd , https://www.irdistancesensor.com